TAMIYA M05 Rear Aluminum Hub Carrier (0 Degree) by 3Racing M05-30/0/LB  [M05-30/0/LB]

Rear hub carrier for M05

This aluminium rear hub carrier is an RC-scale replacement part for the TAMIYA M05 chassis intended for rear suspension tuning where a 0 degree mounting orientation is required. It serves as the structural interface between the rear upright and the chassis, providing a metal alternative to standard plastic components.

As a hop-up option, the part's machined aluminium construction is intended to offer consistent mounting points and reduced flex compared with stock plastic carriers, which helps when evaluating rear geometry changes and suspension setup. Keep in mind this is a chassis-level accessory and does not include electronic components.

Installation typically follows removal of the original rear hub carrier and transfer of uprights and bearings to the aluminium unit, using the chassis' existing hardware and fasteners. Verify alignment and clearances after fitment and check that wheel bearing seating and axle engagement remain correct before running.