Tamiya M06 aluminum front knuckle arms by JAZRIDER M06-13000-LB  [M06-13000-LB]

Aluminum front knuckle arms (light blue)

This is an aluminum front knuckle arm set intended for RC-scale use on the Tamiya M06 chassis. The components replace the standard plastic knuckles to offer a firmer mounting point for the steering linkage and to provide a consistent steering geometry under load.

Manufactured from anodized aluminum in light blue, the knuckle arms focus on dimensional stability rather than altering geometry. They work as a direct hop-up part for M06 steering assemblies and are suitable where a metal replacement is preferred for handling repeatability during setup and tuning.

When fitting these knuckles, transfer any bearings or hardware from the original parts and verify ball stud alignment and steering arm clearance. Check that the steering throws and camber settings remain within your desired range after installation, and inspect mating fasteners for proper fitment to avoid thread damage.

Routine maintenance is limited to visual checks for wear at bearing seats and hardware torque. The anodized finish provides surface protection, but it is still recommended to examine contact points after hard running or frequent adjustments.