This JAZRIDER M06-13002-LB C hub is a direct-fit RC-scale replacement part listed for the TAMIYA M06 chassis, presented in a light blue anodized finish. The piece replaces the stock plastic C hub with an aluminum unit to provide firmer steering feedback and a more consistent pivot point under load, useful when tuning front-end response on 1/10 touring car builds.
Installation is straightforward for anyone familiar with M06 front suspension work: remove the standard C hub and carrier assembly, transfer any required pins or inserts, and secure the aluminum C hub with the original mounting hardware. Check hex screw torque and verify free rotation of the wheel hub and steering knuckle after fitting; slight adjustments to camber and toe may be needed following installation.
As an upgrade part, this C hub affects steering stiffness and alignment repeatability rather than changing ride height or suspension geometry by itself. Use it as part of a measured tuning routine: pair with appropriate ball bearings, confirm steering linkage geometry, and adjust toe or camber to tune handling balance. The light blue finish helps visually identify the upgraded component during setup and maintenance.
Copyright © 2008-2026 rcjaz.com All rights reserved
