TAMIYA M06 Aluminum Rear Shock Tower by JAZRIDER M06-13009-LB  [M06-13009-LB]

Aluminum rear shock tower for Tamiya M06

This JAZRIDER rear shock tower is a purpose-made RC-scale replacement part intended for the TAMIYA M06 chassis. Machined from aluminum, the component provides a stiffer mounting point for the rear suspension than typical plastic towers, helping maintain alignment under load and during iterative tuning sessions.

Fitment and role: the tower locates the rear shock tops and serves as an anchor for suspension geometry adjustments. On track or at the club, a rigid shock tower reduces flex where the shocks meet the chassis, allowing more consistent damping and easier comparison between shock oil, spring, or mounting changes.

Installation notes: this part replaces the standard rear shock tower on the Tamiya M06 platform and installs using the existing chassis mounting points. Inspect existing screw threads and use the original mounting hardware where applicable, tightening progressively to avoid striping plastic bosses on the chassis. The unit is supplied in light blue finish to match common M06 styling options.

Practical tuning tips: when switching to an aluminum tower, re-check camber and toe under preload since the reduced flex can slightly change static measurements; small incremental adjustments are recommended during setup runs to evaluate handling differences.