Tamiya M07 Front Lower Suspension Mount 5degree Caster by 3Racing M07-18  [M07-18]

Front lower suspension mount overview

This front lower suspension mount is an RC-scale hop-up designed specifically for the Tamiya M07 chassis geometry, incorporating a 5degree caster orientation to alter front-end behaviour. It serves as a direct replacement part for the front lower link mounting point and is intended for on-track tuning and setup work where small changes to steering geometry are being evaluated.

Functionally, adding a 5degree caster element shifts the steering axis to influence turn-in and high-speed stability. Use this mount when you need finer control over front grip and self-centering characteristics without changing major suspension components. The part affects handling through geometry, not powertrain or braking systems.

Fitment and installation are straightforward for users familiar with M07 front suspension assemblies: remove the factory lower mount, position the hop-up in the same location, and secure it following the original mounting sequence. After installation, check wheel alignment and steering range, then make incremental setup changes on the track to assess effects on corner entry and mid-corner balance.

Maintenance is typical for suspension hardware on small-scale models: inspect mounting points for tightness and wear after initial runs, and verify no binding in steering linkages occurs as caster changes can alter linkage angles.