Tamiya M07 Rear Suspension Arm by 3Racing M07-06  [M07-06]

Replacement rear arm for M07

This is an RC-scale rear suspension arm produced by 3Racing for use with the Tamiya M07 chassis. It is intended as a direct replacement part to restore or modify the rear suspension geometry on 1/10-scale electric touring cars, and is written for hobbyists who perform routine maintenance, repairs, or setup changes.

The arm focuses on compatibility and installation clarity rather than cosmetic change. It replaces the existing rear arm assembly, returning mounting points and pivot locations to nominal positions expected by M07 setups. Use this part when a rear arm is worn, cracked, or when switching to a spare during trackside repairs.

Installation notes: remove wheel and hub assembly to access the arm, support the chassis while releasing rear pivot hardware, transfer any required ball studs or bushings from the original arm, and torque fasteners to the vehicle manufacturer's recommended values. No chassis modifications are required for standard M07 layouts.

Tuning role: swapping rear suspension arms affects rear track consistency and can change how the rear end responds under cornering and throttle. Use matched arms on both sides and check alignment and droop after installation to keep predictable handling for lap-to-lap setup work.