Tamiya M07 Rear Suspension Mount by 3Racing M07-17  [M07-17]

Rear suspension mount for M07

This is an RC-scale rear suspension mount produced by 3Racing for use on the Tamiya M07 chassis family. It serves as a direct replacement hop-up part that takes the place of the standard rear mount to allow straightforward changes to the rear suspension layout and tuning options.

Fitment is intended specifically for M07-series models. In typical setup work you remove the factory rear mount and install this unit in the same location, then reattach the suspension arms and check alignment and droop as part of your setup routine. The part is intended to support adjustments to rear geometry and complement other M07 upgrades without altering the primary chassis structure.

For tuning, use this mount to experiment with roll centre and toe settings by combining it with different suspension arms or link lengths already available for the M07. Check existing mounting points and fasteners on your car to ensure a clean swap and consistent chassis behaviour after installation.