This aluminium front suspension arm is an aftermarket replacement produced by GPM for use on Tamiya MF01X platforms and M06 compatibles. Supplied as a 1pr set, the component replaces the stock front arm to provide a metal option intended for higher dimensional stability and longer service life compared with standard plastic arms.
The part is intended as a direct-fit RC-scale accessory for the MF01X / M06 layout, using the same mounting points as the factory front arm. Installation follows the chassis' original mounting pattern, so existing hardware can typically be reused, but confirm thread engagement and fastener type before assembly. After installation, check wheel toe and camber and perform a brief test before full use.
In tuning terms, an aluminium arm like this is used to alter front-end stiffness and consistency under load. It is suitable for hobbyists who want a metal replacement as part of a setup progression; adjustments to spring rate, damper settings, and steering geometry should be reviewed after swapping to metal arms to ensure the chassis balance remains as intended.
As a metal replacement arm sold as a 1pr set, this GPM item provides a direct-fit aluminium option for MF01X and M06 front suspension setups, intended for routine tuning and maintenance use.
Copyright © 2008-2026 rcjaz.com All rights reserved
