Tamiya MF01X Aluminium Servo Mount by GPM MF024  [MF024]

Aluminium servo mount for MF01X

This is an RC-scale aluminium servo mount produced for the Tamiya MF01X platform, supplied as a 1pc unit. It replaces common plastic mounts to provide a stiffer mounting point for a servo on MF01X chassis layouts without changing original fitment patterns.

The part is intended to serve a straightforward mechanical role: secure the servo case to the chassis, maintain consistent alignment under load, and limit flex that can affect steering response. As an aluminium component it offers greater rigidity compared with typical injected-plastic mounts, which can help when fine-tuning steering feel or when using higher-performance servos within stock mounting envelopes.

Installation notes: verify the MF01X chassis mounting holes and use the original or equivalent-length screws to avoid thread damage, check clearance against nearby suspension and steering linkages, and confirm servo arm alignment before final tightening. After initial installation, run the servo through full travel to ensure there is no binding or interference at end stops.

Tuning role: this mount is primarily a chassis rigidity and alignment upgrade that influences how servo inputs translate to steering geometry; it does not change servo output or electronics, but can reduce play caused by a flexible mounting point, providing a more predictable mechanical response for setup adjustments.