TAMIYA T3-01 DANCING RIDER Alloy Rear Sway Arm by GPM T3332R  [T3332R]

Alloy rear sway arm overview

This aftermarket rear sway arm is an RC-scale replacement and tuning part designed for the TAMIYA T3-01 DANCING RIDER platform, produced by GPM as model T3332R. It replaces the stock rear sway arm to provide a stiffer, lighter link that changes the roll characteristics of the chassis through adjustable ball end positions.

The arm is machined from aluminum 6061 T6 and includes stainless steel flat head screws, washers, copper bead and white silicone rings used to control play around the screw shafts. Ball connectors at both ends are adjustable; moving them outward increases the vehicle's lean angle and changes roll transfer between the axles, allowing finer cornering balance without modifying suspension geometry.

Installation uses the supplied hardware and follows common T3-01 linkage attachment points, retaining standard ball stud interfaces. The silicone rings act as shims to minimize axial play while preserving small movements needed for natural suspension response.

Use this arm when you want a durable, lightweight rear sway link to refine lean angle and roll behaviour on the T3-01 DANCING RIDER; adjust the ball ends incrementally and test lap‑by‑lap to dial handling to preference.