TAMIYA T3-01 DANCING RIDER Aluminum rear fender and hex adapter by GPM T3333R  [T3333R]

Aluminum rear fender and hex adapter

This is an RC-scale aluminum rear fender and hex adapter set designed for the TAMIYA T3-01 DANCING RIDER chassis. The components are intended to protect the rear tyres from sand and rocks during off-road running and to provide a simple track-width adjustment with thicker hex adapters.

The fenders are machined from 6061 T6 aluminum to keep mass low while retaining tensile strength suitable for cosmetic protection on model vehicles. Hex adapters are manufactured to increase the wheel hex thickness by +3mm relative to original hexes, giving a wider rear track and a marginally different handling balance useful for tuning chassis stability.

Installation is straightforward on the T3-01 platform: fit the aluminum fender in place of the stock plastic unit using the supplied stainless steel screws and washers, and replace the wheel hexes with the +3mm adapters. No additional modifications to rims or hubs are required if the vehicle already accepts standard hex adapters of the same outer diameter.

Use this set when you want a durable, lightweight rear fender for light debris protection and a simple way to widen rear track for tuning. Keep fasteners checked after rough runs and confirm clearances at full suspension droop before competitive use.