TAMIYA T3-01 DANCING RIDER Stainless Steel Rear Wheel Shaft with Aluminum Hex Adapter by GPM T3023SR/+2MM  [T3023SR/+2MM]

Rear wheel shaft upgrade for T3-01

This GPM aftermarket set replaces the stock rear wheel drive components on the TAMIYA T3-01 DANCING RIDER chassis with a stainless steel shaft and aluminum hex adapter solution designed for hobby-grade RC models. The kit transfers torque from the rear gearbox to the wheels while increasing track width by 2mm where fitted.

The design uses a one-piece stainless steel shaft for improved resistance to bending and wear compared with split or thin stock parts, and comes with aluminum hex adapters to match wheel hubs. Screw shafts and stainless steel locknuts are provided to secure the assembly and reduce slop under load.

Installation notes: the shaft assembly integrates with the chassis' rear gearbox output and standard wheel hubs for the T3-01. Ensure threads are clean and use the supplied screw shafts and locknuts to achieve proper preload; check wheel runout after fitting and re-check after a short driving session.

Tuning role: this set is intended to provide a stiffer, more durable drivetrain connection and a modest increase in rear track to influence cornering balance. It is suitable for hobby-scale adjustments to handling and drivetrain reliability on the T3-01 platform.

Use this set when you need a direct, durable replacement for the T3-01 rear drive shafts and when a +2mm track adjustment is part of your setup changes; inspect fasteners after initial runs to ensure stability.