TAMIYA T3-01 Front Aluminium Wheel (5 Poles) by GPM T3050F  [T3050F]

Front aluminium wheel for T3-01

This is a 3pcs set of front wheels produced by GPM for the TAMIYA T3-01 DANCING RIDER RC chassis, intended as a scale accessory for 1/10 class models. Each wheel is machined from T6 aluminium and anodized to resist surface wear while preserving a low mass relative to standard alloys.

The wheel features a modern 5-pole 3D profile intended to match the styling of contemporary touring car builds while remaining an RC-scale component used on the front axle of T3-01 setups. The finish is described as scratch-resistant anodizing in vivid colors, which affects appearance and surface corrosion resistance but not mechanical fit.

Included hardware from the source list: Stainless Steel round head screws 3x10, 2pcs, supplied for wheel mounting where applicable. Verify screw thread and length against your hub before final assembly.

A straightforward aluminium front wheel set for TAMIYA T3-01 builds where reduced mass and anodized surface durability are priorities, note fitment checks before installation.