Tamiya TA05 Aluminium Rear Hub Carrier 0 Degree by 3Racing TA05-16/0/LB  [TA05-16/0/LB]

Rear hub carrier for TA05 (0°)

This aluminium rear hub carrier is an RC-scale replacement part intended for the Tamiya TA05 chassis, specified in a 0 degree configuration. Machined from aluminium and finished in light blue anodizing, it serves as a direct-fit hop-up to replace plastic stock parts where available, providing a predictable change in rear suspension stiffness and wheel location behavior.

Compatibility and fit depend on TA05-series mounting points and hardware; verify your chassis layout before installation. The carrier interfaces with the rear uprights and wheel hubs and retains standard mounting for existing wheel axles and bearings, making it suitable for typical touring car suspension setups on 1/10 scale TA05 models.

Installation notes: use the original mounting screws and follow standard torque values for aluminium components to avoid thread damage. When tuning, treat this part as a stiffness/tolerance change — small adjustments to rear toe and camber settings may be required after fitting. This item is described explicitly as an RC accessory for scale cars and not for full-size vehicles.