Tamiya TA05 Aluminium Rear Hub Carrier 3 Degree by 3Racing TA05-16/3/LB  [TA05-16/3/LB]

Aluminium rear hub carrier for TA05

This is an RC-scale aluminium rear hub carrier designed for Tamiya TA05 chassis with a fixed 3 degree rear inclination. Produced and finished in light blue anodizing, the part replaces the stock plastic carrier to offer a stiffer mounting point for the rear hub and suspension pickup. Its role is limited to chassis tuning where small changes to hub geometry affect camber recovery and roll response.

Installation is straightforward for anyone familiar with TA05 maintenance: remove the original rear hub carrier and fit this unit using the chassis' existing hardware and bearings. No special tools are required beyond the standard hex driver and appropriate size sockets used on TA05 models. After fitting, check rear camber and toe settings and re-tighten hub mounting screws to the recommended torque for aluminium parts to avoid thread damage.

As an accessory for tuning, expect changes in rear stiffness and feedback during cornering; this can influence how the car transfers load between the rear tyres under throttle and during direction changes. It is intended for hobby and track use on 1/10 scale TA05 touring cars only.