Tamiya TA05 chassis Delrin solid axle outer join by 3Racing TA05-IF19  [TA05-IF19]

Delrin outer axle join for TA05

This is an RC-scale Delrin outer axle outer join intended for use with Tamiya TA05 series chassis, supplied as 3Racing TA05-IF19. The component replaces the outer join on a solid axle assembly and is produced in Delrin to provide a low-friction interface while retaining the dimensional stability required for axle alignment.

Installation typically involves removing the wheel hub and outer axle cap to access the existing join, then fitting the Delrin outer join onto the axle end and securing it with the chassis' original fastening hardware. No special tools beyond standard hex drivers are required for the basic swap, but inspect axle fit and clearance before running.

In a tuning context this part is used to fine-tune rotational smoothness at the wheel end and to offer a wear-resistant mating surface compared with some softer plastics. Regular inspection for wear and proper seating helps maintain predictable handling and drivetrain response on club tracks and practice sessions.