TAMIYA TA05-R/TRF415/TRF-416 Aluminium Suspension Mount by 3Racing 415-01/1E [415-01/1E]

Tamiya TA05-R /TRF415 /TRF-416 Aluminium Suspension Mount (1E) - 3Racing 415-01/1E

Price:

USD$4.70

Brand:

3Racing

Model:

415-01/1E

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - TRF415

Aluminium suspension mount for TA05 series

This aluminium suspension mount is an RC-scale replacement part specified for TAMIYA TA05-R, TRF415 and TRF-416 chassis, supplied under 3Racing part number 415-01/1E.

The component is intended to accept standard mounting hardware and integrate into the car's suspension geometry without chassis modification. In practical use it serves as a direct-fit swap to allow stiffer mounting points and consistent alignment when adjusting camber, caster, or ride height on the TA05 family of touring car chassis.

When installing, verify existing hole patterns and fastener lengths, confirm clearance with nearby components such as the servo, ESC and gearbox, and tighten to recommended torque for aluminium-to-aluminium joints to avoid thread wear. Use thread locker on steel screws if reusing hardened fasteners to reduce loosening during track use.

The part is useful in tuning sessions where repeatable suspension mounting is needed for step-by-step setup changes and for replacing worn or stripped plastic mounts with a metal alternative to maintain consistent geometry over multiple runs.

Is this mount compatible with standard TA05-R hardware?

The mount is made for the TA05-R/TRF415/TRF-416 series mounting patterns, confirm hole alignment and fastener length before fitting.

Any installation tips to maintain suspension geometry?

Check clearances with servo and gearbox, use consistent torque on mounting screws, and log changes when adjusting camber or ride height for repeatable setup.