This aluminum front suspension mount set is an RC-scale upgrade intended for TAMIYA TA07 chassis use and is presented in a gun metal finish. It replaces or supplements the stock mounting points to provide a firmer attachment for the front suspension tower, which affects steering response and suspension articulation during tuning sessions.
Installation is straightforward for hobbyists familiar with TA07 maintenance: remove the original front mount, transfer any reusable hardware and bearings, fit the aluminum mount to the chassis using the existing screw points, and verify chassis alignment before test runs. No special tools beyond standard hex drivers are required, but check screw lengths and thread engagement to avoid chassis stress.
On the bench, this mount helps maintain consistent camber and caster under load, making small suspension and steering geometry adjustments more predictable. Use measured setup changes and short test runs to confirm desired handling before full sessions.
Copyright © 2008-2026 rcjaz.com All rights reserved
