This aluminum rear upright hub carrier is an RC-scale replacement part intended for use on the Tamiya TA07 chassis. The component serves as a direct replacement upright/hub carrier fabricated from aluminum to offer a firmer mounting point compared with typical stock materials.
Installation involves removing the rear wheel hub assembly and fitting the aluminum carrier using the vehicle's existing hardware. Before use, verify fitment with your TA07 rear hub, ensure wheel bearings and axle retention hardware are correct, and confirm that clearances allow full suspension travel.
In tuning terms this part is used to stabilize rear wheel location and provide a consistent mounting surface for the wheel hub and associated suspension links. Swapping to an aluminum upright affects how the rear suspension responds to small setup changes, so re-check toe, camber, and roll center after installation.
Notes: This item is an RC-scale spare for the TA07 chassis only, supplied as a non-electrical mechanical part. Compatibility outside TA07 is not specified.
Copyright © 2008-2026 rcjaz.com All rights reserved
