This JR-TA702-DB is an aluminium front C-hub carrier designed for RC-scale use on Tamiya TA07 and TB04 chassis. It serves as the mounting point for the front upright and steering linkages and is supplied with a dark blue anodised finish to match common hop-up aesthetics.
Compatibility is limited to the stated TA07/TB04 platforms, and the part is intended to replace the stock front C-hub carrier while using the original mounting interface and hardware where applicable. Installation typically follows standard front-end service: remove wheel and upright, unbolt the existing carrier, transfer any bearings or bushings, and secure the aluminium carrier to the chassis bellcrank area.
In practical tuning terms the aluminium carrier provides a rigid, metal mounting surface for steering components and the front suspension pickup points, which helps maintain alignment during setup checks and track use. Check fitment for steering throw and servo linkage clearance after installation and verify that existing ball bearings or pins seat correctly.
Maintenance notes: inspect mounting threads and anodised surfaces after heavy use, re-tighten retaining screws to factory torque, and replace any worn pins or bushings rather than forcing mating parts.
Copyright © 2008-2026 rcjaz.com All rights reserved
