Tamiya TB-02 Turnbuckle Set with Ball End by 3Racing TB02-05  [TB02-05]

This turnbuckle set provides adjustable linkage for the Tamiya TB-02 touring car chassis, using ball-end connectors to give predictable pivoting at steering and suspension link points. The parts are intended as direct replacements or hop-up components for RC-scale setups where fine toe and camber adjustment is required.

Installation is straightforward: replace existing turnbuckles at the affected linkage points and adjust length to set the desired toe or camber. Because the set uses ball ends, it allows small angular movement at the joint which helps maintain alignment under suspension travel and steering input. Check thread engagement and secure ball ends to the control arms or steering blocks as needed for your setup.

For tuning, expect to use these turnbuckles to alter front toe-in/toe-out and minor camber offsets; changes here influence turn-in response and mid-corner grip on 1/10 touring layouts. They are a practical option when refining handling balance without changing bulkier suspension parts.

Compatibility

• Tamiya TB-02 chassis