TAMIYA TB04 Spring Steel Steering & Push Rods by GPM TB4160/ST  [TB4160/ST]

Spring steel steering and push rods for TB-04

This aftermarket set is produced by GPM for the TAMIYA TB04 touring car platform and contains eight replacement linkage pieces intended for steering and push-rod duties on TB-04 layouts. Components are made from spring steel to maintain straightness under load and resist bending during typical electric touring car use. The set complements stock plastic rods where improved stiffness and repeatability are desired without changing servo or suspension hardware.

Installation is straightforward on TB-04 steering assemblies that accept standard rod ends and ball studs; replace worn push rods one-for-one and verify thread engagement and lock-nut security. During setup, small incremental changes to rod length will affect toe and steering trim, so measure before trimming and test with the car on stands to avoid binding the suspension or overloading the servo.

Because this is an RC-scale accessory, use these rods only within model setups and race tuning contexts, and inspect rod ends and ball studs regularly for wear when running on abrasive surfaces.