This aluminum front damper stay is an RC-scale replacement part designed for TAMIYA Thunder Dragon and Thunder Shot buggies. As a front damper mount, it changes the rigidity and mounting point consistency compared with typical plastic pieces, helping to stabilise geometry under load and providing a predictable platform for tuning front suspension behaviour.
Fitment and basic installation are straightforward: remove the stock stay, transfer any existing hardware and top caps, and fasten the aluminum stay using the original mounting screws. Use an appropriate hex driver, verify alignment before final tightening, and avoid over-torquing hardware to prevent thread damage. Thread locker may be used on steel screws if desired, but check compatibility with existing components.
Tuning role and notes: this part mainly affects front-end consistency rather than changing suspension kinematics. Expect more repeatable damper positioning and less flex at the mounting points, which helps when adjusting spring rates, damping settings, or anti-roll behaviour. Inspect fit against the shock towers and steering linkages after installation to ensure there is no unintended interference.
Copyright © 2008-2026 rcjaz.com All rights reserved
