Tamiya Thunder Dragon/Thunder Shot Aluminum Front Stabilizer Holder (Blue) by JAZRIDER JR-TSD01-LB  [JR-TSD01-LB]

Front stabilizer holder for Tamiya buggies

This aluminum front stabilizer holder is an RC-scale replacement part intended for Tamiya Thunder Dragon and Thunder Shot chassis. Finished in blue anodized aluminum, the holder provides a rigid mounting point for the front stabilizer linkage used in roll and steering control.

The part is described as fitting the locations used by the factory front stabilizer on the specified Tamiya models, and is intended to be used where a more durable metal mount is preferred over stock plastic pieces. Its role is to provide a consistent pivot and reduce flex at the stabilizer attachment, assisting setup adjustments aimed at front-end roll behaviour and steering feedback.

Installation notes: the holder mounts to the front area of the chassis where the stabilizer connects, using the same attachment points as the original holder on compatible Thunder Dragon and Thunder Shot assemblies. Basic trimming of bodywork or removal of the existing holder may be required depending on your car's configuration, and standard RC workshop tools are typically used to swap the part.

Care and maintenance: anodized aluminum surfaces resist corrosion but should be inspected for burrs or deformation after impacts, and fasteners checked regularly to maintain consistent steering geometry.