This RC-scale aluminum wheel hub adapter is made for Tamiya Thunder shot, Thunder Dragon, Fire Dragon and Terra Scorcher chassis. Supplied as 2pcs in red, the adapter replaces the wheel mounting interface to give a metal contact surface for wheel fitment and setup tasks on 1/10 buggy scale models.
Fit and function: the adapter acts as a direct wheel hub interface for the listed Tamiya models, helping to achieve consistent wheel seating and reducing play that can appear with worn or soft plastic hubs. It is intended as a chassis-level hop-up for wheel alignment and handling adjustments rather than a motor or drivetrain part.
Installation notes: remove the wheel and original hub piece following your chassis manual, slide the adapter into place on the axle/hex stub or over the stub as required by your hub design, secure using the existing wheel nuts or screws, then check wheel runout and free rotation before final testing. Inspect the fit after a short test run and re-check fasteners periodically.
Tuning role: use the adapter when swapping wheel types, testing different offsets, or when you need a repeatable metal mating surface for wheel alignment and bearing seating during setup work on Tamiya buggy builds.
Copyright © 2008-2026 rcjaz.com All rights reserved
