This aluminum front C-hub is an RC-scale replacement part for TAMIYA Thunder shot, Thunder Dragon, Fire Dragon, and Terra Scorcher models. Machined from aluminum and finished in black, the component is intended to serve as a sturdy front steering carrier for 1/10-scale buggies where the original plastic C-hub is being upgraded or replaced.
Functionally, the C-hub locates the front uprights and defines steering geometry. Swapping to an aluminum unit can offer a firmer mount point that affects steering feedback and suspension response; use this part when you need consistent pivot alignment or when refurbishing a front suspension after wear. Verify existing bushings and wheel axles for fit before final assembly.
Installation notes: retain compatible fasteners and bearings from the original assembly unless replacement hardware is specified by your chassis manual, torque screws to avoid stripping, and confirm arm clearance through the full suspension travel after fitting. This article describes an RC accessory only and is intended for hobby-scale vehicles.
Copyright © 2008-2026 rcjaz.com All rights reserved
