TAMIYA TL-01/GF-01/WR-02 Aluminum Rear Lower Suspension Arm (Red) by JAZRIDER TL01-13303-RD  [TL01-13303-RD]

Aluminum rear lower suspension arm for TL-01/GF-01/WR-02

This is an RC-scale rear lower suspension arm produced by JAZRIDER as a replacement part for TAMIYA TL-01, GF-01, and WR-02 chassis layouts. The component is machined from red aluminum and intended as a direct-replacement arm for the rear lower suspension location on compatible models. It retains the same mounting footprint as the original part to preserve geometry while offering a metal option for owners who prefer aluminium components for maintenance or tuning purposes.

Installation is straightforward for users familiar with basic chassis disassembly: remove the wheel and hub carrier, withdraw the hinge pin or retainer, swap the lower arm for the JAZRIDER unit, and verify alignment and free movement of the suspension. Check screw tightness and clearance after a short test run. The part is intended for model-level work only and must be used on RC chassis; it is not for real-vehicle applications.

In tuning terms, replacing a rear lower arm with an aluminum unit mainly affects consistency of suspension mounting and provides a different stiffness profile compared with non-metal alternatives. Builders commonly use metal arms when experimenting with rear suspension geometry, roll center changes, or to standardize components across a fleet of models for repeatable setup checks.