TAMIYA TL-01/GF-01/WR-02 Rear hub carrier (Aluminum, Red) by JAZRIDER TL01-13305-RD  [TL01-13305-RD]

Aluminum rear hub carrier for TAMIYA chassis

This aluminum rear hub carrier is an RC-scale replacement part produced by JAZRIDER and listed for use with TAMIYA TL-01, GF-01, and WR-02 chassis. It is finished in red and intended to serve as the rear wheel mounting and suspension attachment point on compatible TAMIYA platforms. The write-up focuses on fit, installation considerations, and how the part integrates into typical tuning workflows.

Fit and role: The hub carrier locates the wheel hub and provides the mounting surface for suspension links and axle hardware. Use it as a direct replacement where the original hub carrier geometry and mounting points match the TL-01, GF-01, or WR-02 layouts. Verify that hole patterns and bearing bores on your chassis match before installation.

Installation notes: Remove the rear wheel and detach the original hub carrier following your chassis service procedure. Typical tools required include a set of metric hex drivers and small wrenches for wheel nuts and link hardware. Install bearings and axle hardware from the chassis or donor parts; the carrier itself is the structural component and does not imply included bearings or extra fasteners unless specified by the seller.

Tuning and maintenance: When swapping to an aluminum carrier pay attention to torque on mounting screws to avoid thread stress in plastic or composite bulkheads. If you use the carrier to alter suspension geometry, make incremental adjustments and check toe and camber under static wheel load. Periodic inspection for fastener security and bearing play is recommended as part of routine maintenance.