TAMIYA TRACTOR TRUCK Front Chassis Stabilizing Mount by GPM TRU008F  [TRU008F]

Front chassis stabilizer for 1/14 tractor trucks

This is an aftermarket RC-scale front chassis stabilizing mount designed for 1/14 TAMIYA tractor truck models, produced by GPM as part number TRU008F. The part is machined from 6061 T6 aluminum to provide a lightweight, higher tensile stiffness alternative to stock plastic mounts, intended to reduce front-end flex and improve chassis response during towing and loaded runs.

The package includes the stabilizing mount and the mounting hardware shown below, allowing direct replacement of the original front mount where the hole pattern matches the listed TAMIYA models. Installation requires basic hand tools and care to align the mount before tightening the supplied screws to avoid cross-threading the chassis posts.

In setup and tuning, this mount functions as a structural brace: fitting it can change how the front suspension and steering geometry react to load, so check steering linkage alignment and wheel toe after installation. Use the included 3x14 and 3x8 stainless steel round head screws for the respective mounting points, and verify that screw lengths clear any nearby components such as servo horns or wiring.