Tamiya TRF 416 Differential Bearing Housing by 3Racing 416-10D  [416-10D]

Differential bearing housing for TRF 416

This RC-scale differential bearing housing is presented as a direct-fit hop-up for Tamiya TRF 416 assemblies, intended to replace the standard diff housing and sit in the same mounting position as the original part.

Installation follows standard differential disassembly: remove the differential from the chassis, open the diff case, swap the housing component, and reassemble while checking bearing seating and alignment. Follow the original screw locations and torque settings specified by the TRF 416 service guidance.

In setup and tuning, the housing's role is to keep differential bearings and gears aligned under load; consistent seating and correct clearances help avoid premature wear and maintain predictable diff behavior during acceleration and cornering for 1/10-scale racing setups.