TAMIYA TRF104 Rear Wing Mount Graphite 2.0 by Factory Pro O-TCPF07  [FP-O-TCPF07]

Rear Wing Mount for TRF104

This Factory Pro O-TCPF07 rear wing mount is an RC-scale accessory made for the TAMIYA TRF104 chassis, intended as a direct replacement or upgrade for the standard rear wing mounting point. The part is produced in a graphite variant labeled 2.0 to provide a firmer mounting surface compared with typical plastic mounts, while keeping the component lightweight.

Compatibility is specific to the TRF104 platform; fitment depends on the chassis' original wing post locations and hardware. The mount interfaces with the existing wing and wing supports used on TRF104 kits, retaining the same mounting footprint so no chassis modification should be required for standard setups.

Installation is straightforward for an experienced hobbyist: remove the original mount, position the Factory Pro unit to align with the wing posts, and refit the original fasteners. Verify wing clearance and symmetry after tightening, and check that the mount does not contact adjacent body or chassis parts when suspension cycles.

Tuning role: a stiffer rear wing mount reduces unwanted flex at the mounting point, helping the wing hold its set angle under aerodynamic load. That stability can make wing adjustments more predictable during cornering and high-speed sections, allowing finer changes to rear downforce and balance without the mount shifting under load.