Tamiya TT01 42 Pitch 60T Delrin Spur Gear by GPM DTT4260T  [DTT4260T]

Spur gear for TT01 drivetrain

This Delrin spur gear is intended as an aftermarket replacement for the Tamiya TT01 1/10 touring chassis where a 42 pitch, 60-tooth spur is required. As a scale RC drivetrain component, the part focuses on material choice and fitment rather than altering vehicle fundamentals.

Delrin offers a balance of wear resistance and low friction compared with softer plastics; that makes this spur suitable for routine maintenance or mild tuning of gear mesh and drivetrain responsiveness. Use it to replace a worn 60T spur or to restore correct tooth engagement after upgrades to pinion gears or bearings.

Installation notes: verify the pinion gear is the correct 42 pitch type, set the mesh with the motor pinion using standard shimming practices, and check that bearings and shaft play are within expected ranges for TT01 layouts. Run brief tests at low throttle to confirm smooth engagement before full-power use.