Tamiya TT-01 Aluminium Bearing Steering Saver by 3Racing TT01-07/LB  [TT01-07/LB]

Aluminium steering saver for TT-01

This aluminium bearing steering saver is an RC-scale replacement part intended for the Tamiya TT-01 chassis, supplied as 3Racing part TT01-07/LB. It uses an aluminium housing with integrated bearing interface to provide a stiffer, longer-wearing alternative to common plastic steering savers used on budget kits.

Functionally the part sits in the steering assembly to limit wear where the servo output and steering linkages pivot, helping to keep steering geometry consistent under repeated use. The light blue anodized finish identifies material and cosmetic choice without affecting fitment.

Installation is a direct-swap for the stock saver on TT-01 style steering assemblies, reusing the original mounting points and hardware from the kit. After fitting, check steering travel and linkage freeplay, then tighten fasteners to avoid binding while preserving smooth bearing rotation.

Tuning notes: this component is primarily for durability and a firmer steering feel; it does not alter servo response or change suspension geometry. Use it where consistent steering input and reduced component wear are priorities, such as repeated club runs or practice laps.