Tamiya TT02 33mm Steel #45 Front/Rear CVD Swing Shaft by GPM STT2233  [STT2233]

Front/Rear CVD swing shaft for TT02

This GPM aftermarket swing shaft is a direct-replacement driveline component designed for Tamiya TT02 series models. The part is presented as a front/rear CVD swing shaft in 33mm length, manufactured in Steel #45 for a balance of hardness and wear resistance appropriate to RC-scale drivetrains.

The component's role is to transfer torque through the front and rear constant-velocity joints while allowing the suspension to articulate; using a harder steel shaft can reduce deformation under load and help maintain consistent pinion-to-spur engagement during aggressive cornering or higher-power setups.

Installation notes: this is a like-for-like replacement intended to fit the stock TT02 CVD housings and related hardware. Check existing set screws and retaining clips for wear, verify clearance with the driveshaft cups, and confirm spline alignment before final torqueing. Use threadlocker where the original manufacturer recommends it, and service surrounding 走珠軸承 and joint boots when replacing driveline parts.

Use this shaft when you need a direct steel replacement for TT02 front or rear CVDs and when tuning for consistent driveline behaviour under load; verify fit and service adjacent components during replacement.