Tamiya TT-02B Aluminum Front Suspension Arms Set by JAZRIDER JR-TT2B04-LB  [JR-TT2B04-LB]

Aluminum front suspension arms for TT-02B

This is an RC-scale aluminum front suspension arm set intended for the Tamiya TT-02B chassis. The light blue anodized finish identifies the part visually while the aluminum construction focuses on increased durability compared with standard plastic arms. Use this set when replacing worn front suspension arms or when upgrading front-end rigidity for consistent handling on track or club layouts.

Installation is direct-fit for TT-02B mounting points. Replace the original front arms using the stock pivot pins and hardware where compatible, verify alignment of mounting holes before torqueing fasteners, and check clearance with steering linkages and servo horns. Because aluminum alters chassis stiffness, expect small changes in steering feedback and rebound response; retune camber, toe, and shock damping as needed to restore balance.

Tuning notes: confirm compatibility of hex sizes and check existing ball bearings or bushings for wear during the swap, use correct-length hex screws when reusing hardware, and test the car at low speed after installation to confirm smooth steering and suspension travel.