Tamiya TT02B Spring Steel Turnbuckle 7pcs set by GPM TT2B160P  [TT2B160P]

Turnbuckle set for Tamiya TT02B

This is a seven-piece turnbuckle set intended for scale RC use on Tamiya TT02B chassis. Each rod uses spring steel for the main shaft with molded plastic end cups, providing a balance between strength and cost for routine tuning and replacement of worn linkages.

Turnbuckles allow length adjustment in steering and suspension linkages to fine-tune toe, camber link geometry, and roll steer on the model. The plastic-ended sockets accept standard ball studs and are sized for typical TT02B linkage points; confirm fit before installation on any modified components.

Installation is straightforward for experienced model technicians: remove the stock links, match thread pitch and length, then set static geometry and recheck with the chassis on a flat surface. Use appropriate thread-locking practice where needed and verify no binding at the servo, linkage, or suspension pivots. This product is an RC-scale accessory and is not intended for real vehicle use.

Use these turnbuckles when replacing worn TT02B linkage components or when adding incremental adjustability during setup; inspect ends and threads regularly during maintenance cycles.