TAMIYA WR02/DT03T Front Upright Aluminum Set by JAZRIDER JR-WR201-LB  [JR-WR201-LB]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Light Blue)
Price:
USD$9.20
Brand:
JAZRIDER
Model:
JR-WR201-LB
Condition:
Brand New
Available in shop
Write a review

Aluminum front uprights for WR02/DT03T

This is an RC-scale aluminum front upright set intended for TAMIYA WR02, DT03T and Blitzer Beetle chassis. The light blue anodized finish identifies the aluminum upgrade without changing mounting geometry, and the parts are supplied as a matched set for left and right front uprights.

Use this set when you want a stiffer, more repeatable steering pivot compared with stock plastic uprights. In practical tuning workflows the uprights act as a rigid connection point for steering linkages and front suspension components, helping to maintain alignment under load and making setup changes more consistent between runs.

Installation notes: the uprights are designed to match the standard mounting locations on WR02/DT03T/Blitzer Beetle front assemblies, so replacement typically uses existing suspension pins and hardware from the original parts. Check fit and free movement of the steering links and suspension travel after installation, and verify no binding occurs through the full range of motion.

Will these uprights fit my WR02 or DT03T without modification?

They are made for WR02, DT03T and Blitzer Beetle front assemblies and are intended to use the standard mounting points, expect a direct replacement but always verify fit before running.

Do these uprights require different hardware or bearings?

No special hardware is listed with the part description, plan to reuse compatible pins and bearings from the original front upright assembly.

What tuning effect should I expect from aluminum uprights?

Expect reduced flex at the steering pivot compared with plastic parts, which helps with repeatable toe and camber during aggressive cornering and setup changes.

Copyright © 2008-2026 rcjaz.com All rights reserved