This aluminum front upright set is an RC-scale replacement part designed for Tamiya WR02, DT03T and Blitzer Beetle front suspension assemblies. It focuses on providing firmer support for the steering knuckle area to reduce deflection under load, helping steering inputs remain consistent during aggressive cornering and varied terrain.
Installation follows standard front upright replacement steps used on these Tamiya chassis: remove the wheel hub and associated hardware, swap the upright while keeping existing bearings and fasteners, then check steering geometry and kingpin alignment. No special tools are required beyond common hex drivers and pliers typically used for Tamiya maintenance.
For tuning, consider this part as a rigidity upgrade: it pairs with stiffer suspension settings or higher-durometer bushings to sharpen steering response. Adjust toe-in and camber after installation to compensate for any change in front-end behaviour, and verify no binding occurs across the suspension travel.
Copyright © 2008-2026 rcjaz.com All rights reserved
