This is an RC-scale aluminum front upright set finished in red anodize, intended as a direct replacement for compatible Tamiya WR02, DT03T and Blitzer Beetle front uprights. The parts are offered as a metal alternative to common plastic pieces to provide consistent mounting points for steering and suspension linkages without claiming specific performance gains.
Installation is straightforward on models that use the same front upright footprint: remove the original upright, transfer any wheel hexes and bearings, and refit using the existing hardware where possible. Verify steering linkage geometry and clearance after installation, and check that wheel bearings and hex fitments seat correctly before first run.
In tuning terms, metal uprights help preserve suspension geometry under repeated loading and make setup changes reproducible, which is useful when adjusting camber, caster, or track width during on-track testing. They are compatible with standard servo and suspension layouts used on the listed Tamiya chassis; no additional tools are required beyond those used for routine maintenance.
Copyright © 2008-2026 rcjaz.com All rights reserved
