Team Associated RC18T Alloy Front Standard Sinkage Surface Rims by GPM AR0403F  [AR0403F]

Front sinkage surface rims for RC18T

This alloy front rim is an RC-scale replacement part produced by GPM for Team Associated RC18T platforms, intended to restore or tune the front wheel contact geometry where a concave/sinkage surface is required. The design focuses on repeatable fitment to the RC18T front hubs and on providing a durable mounting surface for common short-course style tyres.

The part matches the original mounting pattern specified for RC18T front wheels and uses an alloy body for consistent stiffness and wear resistance compared with typical plastic rims. It is appropriate for hobby-level maintenance, race-prep swap-outs, and bench tuning where front-end sink characteristics are adjusted to influence handling.

Installation is straightforward for users familiar with RC wheel removal: remove the wheel assembly, fit the rim to the hub aligning the mounting holes, then secure with the original hardware. No special tools are required beyond standard hex drivers used on RC models. Note this is an RC accessory for 1/18 scale use and not intended for real vehicle application.