Team Associated RC18T/RC18R Aluminum Rear Toe Out Mount 0 Degree by 3Racing RC18-016/SI  [RC18-016/SI]

Rear toe-out mount for RC18T/RC18R

This aluminum rear toe-out mount is an RC-scale replacement part designed for Team Associated RC18T and RC18R chassis. It provides a fixed 0° toe-out reference for the rear wheel hub assembly and is intended for tuning and setup work on 1/18 scale racing models.

The part matches the RC18T/RC18R mounting pattern and is used where a durable, stable mounting point for rear toe adjustment is required. As an aluminum component, it offers increased stiffness compared with standard plastic mounts, helping keep toe settings consistent under load.

Installation is straightforward on compatible RC18T/RC18R rear hub layouts, using the original mounting locations and hardware. Ensure fasteners are tightened to a moderate torque to avoid thread damage and check alignment after initial runs; the mount acts as a fixed geometry piece rather than an adjustable link.

For tuning, this mount is useful when validating baseline suspension geometry or when a repeatable 0° rear toe-out is needed during setup iterations. Regular inspection for burrs or loosening is recommended after track sessions to maintain predictable handling.