TEAM CORALLY SKETER XL4S 13mm Aluminum Hex Adapters by GPM SKE010/+13MM  [SKE010/+13MM]

13mm aluminum hex adapters for SKETER XL4S

This is an RC-scale 13mm hex adapter set made for the TEAM CORALLY SKETER XL4S chassis, supplied by GPM as model SKE010/+13MM. The adapters mount between the knuckle arms and the wheels to change wheel spacing without modifying the hub or axle geometry.

The design uses multiple threaded holes to offer different offset options, allowing incremental changes to track width. Adjusting the wheelbase with these adapters can improve vehicle stability during straight-line runs and when negotiating turns, helping to tune handling for specific track surfaces or driver preference.

Installation notes: fit the adapters at the wheel hub interface, secure with the supplied screws, and verify wheel runout and clearance after installation. These adapters are an aftermarket RC accessory intended for 1/10 scale SKETER XL4S setups and should be checked for proper fit before each run.

Package contents and references taken from the source: Hex Adapter - 2pcs, M4x3x15 Screw Shaft - 2pcs, M4x2.5x15 Screw Shaft - 2pcs, original part number C-00180-329.