TEAM LOSI MINI-T 2.0 Rear Gear Box by GPM LM013  [LM013]

Aluminum rear gear box for Mini-T 2.0

This is an RC-scale aluminum rear gear box assembly designed for TEAM LOSI MINI-T 2.0 2WD platforms. The set replaces the rear gear box area components and acts to stabilize the rear differential, the dampers and the knuckle arm mounts. Built as an aftermarket hop-up, it focuses on accurate fit and material strength rather than cosmetic change.

Material and machining are central to this part: CNC-finished aluminum 6061 T6 offers higher tensile strength and improved thermal conductivity compared with typical plastic housings, which helps the spur and surrounding gears shed heat under sustained runs. The tighter machining tolerance reduces unwanted play around the rear differential and steering link interfaces, aiding predictable handling when you adjust suspension or differentials.

Installation notes: this kit replaces the rear gear box area and includes all fasteners needed for the swap, consult chassis layout and keep original bearings and shafts in place unless specified otherwise by your build manual. Use proper thread engagement on the supplied stainless screws and do not overtighten to avoid deforming the aluminum mating surfaces. Verify differential preload and wheel toe after installation as geometry changes can affect handling.

This aluminum rear gear box is intended as a direct-fit aftermarket replacement to add rigidity and improve thermal behavior in the rear gear area of the Mini‑T 2.0 2WD; treat it as a tuning component when adjusting rear differential and suspension settings.