Team Powers TP-Radon-SW-80 Radon Series signal wire (80mm)  [TP-Radon-SW-80]

Radon Series Sensor Signal Wire (80mm)

This Radon Series signal wire is a dedicated sensor lead intended for sensored brushless motor and ESC signal wiring on RC models. It provides a compact 80mm length suited to most common motor-to-ESC routing layouts without adding unnecessary slack.

Installation is straightforward: route the wire along existing harness paths, avoid crossing high-current supply cables, and secure with heatshrink or small cable ties where the run passes through tight spaces. Where terminal access exists you may solder the conductor or use a matching connector to maintain a reliable sensor contact; ensure insulation is restored and strain relief is applied after the joint is made.

For tuning and reliability, keep sensor signal runs as short and direct as possible, check pin orientation before final assembly, and avoid sharp bends at solder joints. Proper routing and secure fixation help maintain consistent sensor feedback during setup and track play.