TRAXXAS 1/10 Rustler VXL Alloy Front Bumper by GPM RUS003F  [RUS003F]

Alloy front bumper for Rustler VXL

This is a 1/10-scale alloy front bumper produced by GPM for TRAXXAS Rustler VXL chassis, intended as a direct aftermarket replacement for the original front bumper. It is described strictly as an RC-scale accessory and designed to bolt into existing mounting points used on the Rustler VXL platform.

The bumper serves two practical purposes: it provides a more durable contact surface than typical stock plastic bumpers, and it offers a stable interface for tuning front-end feel during short course or bashing sessions. Expect a firmer front impact response compared to stock plastic, which can change how the vehicle behaves in collisions and corner bite during adjustment.

Installation is straightforward for hobbyists familiar with basic RC maintenance. Remove the stock bumper and reuse the factory mounting holes and hardware where possible, checking screw lengths and thread engagement before final tightening. Minimal trimming or adjustment should be required when fitting to a standard Rustler VXL chassis, but verify alignment and clearance around the servo, ESC, and front suspension components after installation.

Practical notes for setup and tuning:

• Confirm the bumper aligns with factory screw locations and does not impede servo horn travel.
• Check for contact with front suspension components through full range of motion; adjust mounting if necessary.
• Use existing hardware where compatible, and replace any worn screws with appropriate hex screw lengths to maintain secure attachment.