TRAXXAS 1/10 Rustler VXL Alloy Rear Knuckle by GPM RUS022  [RUS022]

Rear knuckle for Rustler VXL

The GPM RUS022 is an alloy rear knuckle produced for use with the TRAXXAS 1/10 Rustler VXL chassis. Designed as an RC-scale replacement part, this component serves the rear steering assembly and integrates into the vehicle's rear suspension geometry.

This item is supplied as a single pair, intended for the left and right rear positions. As an alloy part it provides a stiffer interface than common molded plastics, which can affect rear suspension response and long-term wear at the pivot points. Use it where increased rigidity or longevity at the rear steering knuckle is required.

Installation considerations are practical and straightforward: verify fit against the stock knuckles on a Rustler VXL, transfer any required pins or fasteners, and check clearance for axle and drive components after fitting. Routine checks of mounting hardware and bearings after initial use are recommended to confirm alignment and secure attachment.

For builders and tuners replacing stock rear knuckles on a Rustler VXL, this alloy unit offers a durable alternative that supports suspension tuning and keeps rear steering geometry consistent during extended running.