TRAXXAS 1/10 Rustler VXL Stainless Steel Thickened Tie Rods by GPM RUS4160S  [RUS4160S]

Stainless steel tie rods for Rustler VXL

This 21pcs set is an RC-scale steering and linkage upgrade designed for TRAXXAS chassis, supplied by GPM as RUS4160S. The kit focuses on front and rear upper arm turnbuckles to stabilise steering geometry and improve linkage rigidity without changing factory layouts.

The kit uses stainless steel hardware for corrosion resistance and dimensional stability. The thickened tie rod bodies increase bending resistance compared with standard thin-wall turnbuckles, while the adjustable clockwise and counterclockwise threaded ends allow precise toe and steering trim adjustments during setup and tuning.

Included hardware in the set: Tie Rod - 7 pcs, Stainless Steel Round Head Screws 3x16 - 10 pcs, Stainless Steel Flat Head Screws 3x16 - 2 pcs, Stainless Steel Round Head Screws 3x12 - 2 pcs. These parts are intended for model-level assembly and replace OEM link components where thread and length match.

Installation notes: verify thread compatibility with your existing rod ends before fitment, use appropriate thread-locking compound if required by your setup, and check toe settings after installing to ensure symmetric steering response. The adjustable turnbuckles can be used to fine-tune camber and toe when paired with standard ball ends and rod ends.

Use these stainless steel tie rods when you need a direct-fit, adjustable replacement to stabilise steering linkage and refine handling on 1/10 TRAXXAS models listed above.