TRAXXAS 1/10 Slash 4x4 Front CVD Drive Shaft with 12mmx6mm Wheel Hex by GPM SSLA1280FH  [SSLA1280FH]

Front CVD drive shaft for Slash 4x4

This front CVD drive shaft is an aftermarket replacement part designed for TRAXXAS 1/10 Slash 4x4 scale models. It combines steel and aluminium elements to balance strength and reduced rotating mass while keeping the component clearly within RC scale use only. The part replaces the stock front driveline pieces and is intended to integrate with the Slash 4x4 front axle assembly without implying any real vehicle application.

The CVD head and wheel hex were updated from earlier designs to improve retention at the hub interface, and the assembly includes an adjustable length feature to help fit different front-end geometries. Those design choices make it suitable for modelers who want a direct-fit aftermarket front drive solution that can tolerate more aggressive driving and tuning adjustments common in off-road RC trucks.

Installation notes: the drive shaft is a direct replacement intended to slide into existing crosspins and hubs used on Slash 4x4 front assemblies. Expect to check pin seating, hex tightness, and axle alignment during installation. Standard workshop practice applies, use the correct hex drivers and verify the wheel hex is secured to the hub before running the model.

For technicians and hobbyists focused on front-end driveline durability and tighter hub retention, this GPM replacement offers a practical upgrade path for Slash 4x4 trucks while remaining straightforward to install and tune.