TRAXXAS 1/10 Slash 4x4 Front/Rear CVD Drive Shaft by GPM SSLA1278FRPP  [SSLA1278FRPP]

Front/Rear CVD Drive Shafts for Slash 4x4

This 6pcs set is an RC-scale replacement kit intended for TRAXXAS 1/10 Slash 4x4 setups that use GPM part references SSLA1280FH and SSLA1277RH. The components are supplied to stabilise CVD joints and provide the small hardware required to secure the shafts during assembly and maintenance.

Included parts cover the common wear points around a CVD joint so you can service front and rear drives without sourcing multiple small items separately. The set is suitable for hobby use where maintaining smooth, reliable driveline operation is the priority, and it matches the fitment points used by the referenced GPM components.

Installation notes: remove the wheel and hub assembly, release the existing CVD retaining pins and collars, fit the drive shaft, then re-install pins and collars ensuring free rotation without binding. Verify clearance under full suspension compression before finalising fasteners. Use thread-locking compound only where the original design calls for it.