TRAXXAS Slash 1/10 4x4 Steel Pin by GPM SSLA1277RH/P  [SSLA1277RH/P]

Steel pin for CVD joints

This is a steel replacement pin designed for the CVD joint area on 1/10 scale TRAXXAS Slash 4x4 models, sold as an aftermarket part by GPM (SSLA1277RH/P). The item replaces the factory pin in the CVD joint to restore a secure drivetrain connection where the pin locates and retains moving CV components.

Fit and compatibility are referenced to the original listing: intended for use with TRAXXAS Slash CVD assemblies identified by SSLA1280FH and SSLA1277RH codes. Use this pin where the joint pin secures the CVD yoke or cup, and confirm the part code matches your current hardware before installing.

Installation notes: this is a direct replacement pin for the joint location on the CVD, so minimal disassembly of the driveshaft and CVD housings is required to remove the worn pin and install the new one. Check mating surfaces and surrounding retaining hardware for wear while replacing the pin and reassemble with the same clearance and orientation as the original part.

Tuning and maintenance role: swapping to a fresh steel pin restores positive locating of the CVD components and reduces play that can affect drivetrain feel. When troubleshooting driveline lash or intermittent binding, inspect the pin and surrounding CVD surfaces as a routine maintenance step.

Includes 2 pcs steel pins, sold as a replacement pair for the specified TRAXXAS CVD joint locations, and noted as a direct replacement for GPM Racing #SSLA1277RH / SSLA1280FH.